175
ECS Gen. 2
Alternative axle load distribution
CAUTION
The alternative load distribution must be within the
permitted range for the particular truck/suspension/tyre
variant.
An alternative axle load distribution figure is programmed,
and activated by pressing the function switch.
The function is de-activated at road speeds > 30 km/h, and
must be re-activated by pressing the function switch, or by
switching the ignition off and on.
This function is not available when function 1 is active or
requested.
DIH on pin X2-06 (BHA-8) to activate alternative axle load
distribution.
One x 2 position switch - (BHC)
Function 8
U
To Next Page
