FOREWORD
This workshop manual contains repair instructions for the MD5A marine diesel engine. The instructions
concerning overhauling describe the most suitable working method to be used with the special tools listed under
the heading “Special tools”.
Both the engine designation and its serial number must be clearly stated in all correspondence concerning the
engine and when ordering spare parts. We reserve the right to carry out design modifications and, for this
reason, the contents of this manual cannot he regarded as binding.
AB VOLVO PENTA
Technical Information Department
NEW UNITS OF MEASUREMENT
Technicians have long since tried to establish an internationally standardized system of
measurements. In 1960 a decision was made to use a system called SI (Systéme International
d’Unites). To a large extent, this system is based on earlier systems but the units have been
made uniform so that no conversions are necessary.
The SI-system is now being applied within industry in Europe, This manual contains the new SI-
units. The units used previously however, are also stated but in brackets.
The new units are:
Output is slated in kW (kilowatts)
earlier unit h.p. (horsepower)
Torque is stated in NM (Newton-metres)
earlier unit kpm (kilopond-metres)
Engine speed is stated in r/s (revolutions per second)
earlier unit r.p.m. (revolutions per minute)
Displacement and volumes are stated in dm
3 (
cubic decimetres)
earlier unit l (litres)
Pressure is stated in Pa (Pascal)
earlier unit kp/cm
2
(kiloponds per square centimetre).
Reproduction permitted if source quoted
To Next Page
Loading...
