Standard STD 101-0001
Volvo Group
Version
4
Page
8
Query
Visual response
Figure 6a Figure 6b
b) Associativity
The represented line element, the tolerance frame and the controlled feature should be organized as an
associated group, see figure 6b.
4.1.5 Part features not fully modelled
A conventional simplified representation of part features such as threads and splines may be shown using a
partial geometry definition, annotations, attributes or a combination thereof.
4.1.6 General methods requirements
4.1.6.1 Data set methods
The following subsections cover the product-definition methods listed below. Each different method for specifying
product definition is used in support of different industry processes and requirements. The data set is the original
for all the methods. Any copy, no matter what the media of presentation, is subordinate.
4.1.6.2 Model only
The following is applicable when a model, but no drawing, is used as primary document in the definition of a part.
a) Product-definition data including, but not limited to notes, marking requirements, dimensions and
tolerances shall be contained or referenced in the data set.
4.1.7 Title block on model
When model-only (annotated models) is used, a title block in accordance with STD 910-0001 shall be included in
the model. The title block shall be placed on the general-notes annotation plane which is possible to display on
request and which does not rotate with the model. See section 4.4.
To Next Page
Loading...
