Vorwerk KOBOLD - Placing the charging unit

11
Preparation
2.1.2 Charging without charging unit
• Ensure that the Kobold VC100 handheld vacuum cleaner is switched off.
• Press the pin on the charging unit to open it.
• Insert the small plug of the mains charger in the corresponding socket on the
handle of the handheld vacuum cleaner.
• Then insert the mains charger into the socket.
The function indicator shows that the handheld vacuum cleaner is being
charged.
The function indicator goes off as soon as the baeries are fully charged (aer
approx. 4 hours). To achieve optimum charing, the handheld vacuum cleaner
must be charged until the function indicator goes off.
2.2 Placing the charging unit
Choose the fixing material in accordance with the properties of your wall.
• You need a screw to mount the charging unit
4
to the wall.
• Fasten the screw to the wall.
Ensure that the distance to the floor is at least 50 cm.
• Place the charing unit with the intended opening on the hook or screw.
You can also place the charing unit on an even surface (e.g., table or worktop).
Fig. 2.3 Opening the charing unit
Fig. 2.4 Charing without charing unit
4
4
> 50 cm
Fig. 2.5 Haning up the charing unit