29
Wall mounted.
The Meter is placed in front of the mounting surface.
See the picture below. If the Meter needs to be angled
downwards, more than the shown mounting position
allows, the stand can be mounted with the top angled
downward instead.
Connections
The picture below shows the rear view of the 9150
Meter with connectors. The screw terminal blocks are
detachable to allow for easy replacement of the Meter
and to allow for access to the terminal screws when
connecting the wires.
To avoid the risk of connectors being pulled out of the
Meter it is recommended to use cable straps to secure
the cables to the cable strap loops at the rear of the
Meter.
12345
1231234
123456
P5
P4 P3
P7
I/O connector
Power connector
JBox connector
Printer connector
Cable strap loops
To Next Page
Loading...
General