VTech BM4000-BEAR - Page 48

40
41
Appendix
Troubleshooting (continued)
The video and audio monitor produces high-pitched
noise.
The parent unt may be too close to the baby unt or another parent
unt. Make sure the parent unts and the baby unt are at least
1 metre away from one another.
You may be too close to the baby unt or another parent unt when
you press and hold TALK. Make sure the parent unts and the baby
unt are at least 1 metre away from one another.
You may have set the senstvty level too hgh. You may need toYou may need to
adjust the senstvty level to a lower level to avod audo feedback
(pages 26 and 27).
My parent unit plays any sounds from the baby unit and
I think it is too noisy.
You may have set the senstvty level to the hghest level (Level 5).
If you do so, the baby unt wll transmt any sounds detected to the
parent unts. You may need to adjust the senstvty level to a lower
level (pages 26 and 27).
You may need to adjust the speaker volume on the parent unt
(page 24).
My parent unit beeps.
The baby unt may be out of range. Move the parent unt closer to
the baby unt (but not less than 1 metre).
If the parent unt s powered by the provded battery, t may not
have enough charge for the parent unt to perform normally.
Charge the battery n the parent unt for up to 3 hours.
The temperature of your baby’s room may be too hgh or too low
(pages 32 and 33).
•
•
•
•
•
•
•
•