VTech CS6199-4 User Manual

44
Answering system settings
Remote access code
A two-digit security code is required to access the answering system remotely from
any touch-tone telephone. The preset code is 19. You can set the code from 00 to 99.
Press MENU when the phone is not in use.
Press or to scroll to Answering sys, then press SELECT.
Press or to scroll to Ans sys setup, then press SELECT.
Press or to scroll to Remote code, then press SELECT.
Use the dialing keys (0-9) to enter a two-digit number,
or press or to scroll to a desired two-digit number.
Then press SELECT to conrm your selection. You hear a
conrmation tone.
Message alert tone
When the message alert tone is set to on, and there is at least one
new message, the telephone base beeps every 10 seconds.
To turn this feature on or off:
Press MENU when the phone is not in use.
Press or to scroll to Answering sys, then press SELECT.
Press or to scroll to Ans sys setup, then press SELECT.
Press or to scroll to Msg alert tone, then press SELECT.
Press or to choose Tone: On or Tone: Off, then press
SELECT to conrm your selection. You hear a conrmation tone.
The answering system must be turned on for the message alert
tone to be functional.
Press any key on the telephone base (except ) to temporarily
silence the message alert tone.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
•
•
Remote code
ANS ON
ECO
Remote code
19
ANS ON
ECO
Ans sys setup
ANS ON
ECO
Msg alert tone
ANS ON
ECO
Tone: Off
ANS ON
ECO
Ans sys setup
ANS ON
ECO

VTech CS6199-4 Specifications

Frequency

transmit frequency (handset)	1921.536-1928.448 MHz
transmit frequency (telephone base)	1921.536-1928.448 MHz
channels	5

Power Requirements

handset battery	2.4V Ni-MH
telephone base power	6V DC @ 400mA
charger power	6V AC @ 300mA

Memory

handset directory capacity	50 memory locations
handset directory digits	up to 30 digits
handset directory characters	15 characters