3
Getting started
Place the battery with the label
THIS SIDE UP facing up and the
wires inside the battery compartment.
2.Insert the battery connector securely
into the socket, matching the
orientation of the engraved label.
1.
Slide the battery compartment cover
towards the center of the handset
until it clicks into place.
3. Place the handset in the telephone base
or charger to charge.
4.
Battery installation
Install the battery as shown below.
If the handset will not be used for a long period of time, disconnect and remove the
battery to prevent any possible leakage.
To purchase replacement batteries, visit our website at www.vtechphones.com or
call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call 1 (800) 267-7377.
•
•
The LCD backlight
turns on for
10 seconds to
denote the battery
starts to charge.
IMPORTANT:
Check for a dial tone by pressing . If you hear a dial tone, the installation is successful.
If you do not hear a dial tone:
Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service to digital service
from a cable company or a VoIP service provider, the telephone line may need to be rewired
to allow all existing telephone jacks to work. Contact your cable/VoIP service provider for
more information.
•
•
To Next Page
Loading...
Need help?
Frequency
Memory
