VTech DS6511 User Manual

3
If the handset will not be used for a long time, disconnect and remove the battery
to prevent possible leakage.
To purchase replacement batteries, visit our website at www.vtechphones.com
or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or dial
1 (800) 267-7377.
•
•
Handset battery installation
Install the battery as shown below.
CHARGE light
remains on
when charging.
Getting started
Plug the battery connector securely
into the socket inside the handset
battery compartment, matching the
orientation of the engraved label.
1. Place the battery with the label
THIS SIDE UP facing up and
the wires inside the battery
compartment.
2.
Align the cover flat against the
battery compartment, then slide it
towards the center of the handset
until it clicks into place.
3. Charge the handset by placing it
in the telephone base or handset
charger. The CHARGE light is on
when the handset is charging.
4.
IMPORTANT:
Check for a dial tone by pressing /HOME. If you hear a dial tone, the installation
is successful.
If you do not hear a dial tone:
Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service
to digital service from a cable company or a VoIP service provider, the
telephone line may need to be rewired to allow all existing telephone jacks to
work. Contact your cable/VoIP service provider for more information.
•
•

VTech DS6511 Specifications

Technical Specifications

transmit frequency handset	1921.536-1928.448 MHz
transmit frequency telephone base	1921.536-1928.448 MHz
channels	5

Power Requirements

handset power requirement	2.4V Ni-MH battery
telephone base power requirement	6V DC @ 400mA
charger power requirement	6V AC @ 300mA

Memory

handset directory memory locations	200 memory locations
handset directory digits	up to 30 digits
handset directory characters	15 characters