Getting started
4
Handset battery charging
Once you have installed the battery, the screen indicates the battery status (see the
following table).
For best performance, keep the handset in the telephone base or handset
charger when not in use.
The battery is fully charged after 12 hours of continuous charging.
If you place the handset in the telephone base or handset charger without
installing a battery, the screen displays NO BATTERY.
Battery indicators Battery status Action
The screen is blank, or
displays Put in charger
and flashes.
The battery has no or
very little charge. The
handset cannot be used.
Charge without interruption (about
30 minutes).
The screen displays
Low battery and
flashes.
The battery has enough
charge to be used for a
short time.
Charge without interruption (about
30 minutes).
The screen displays
HANDSET X.
The battery is charged. To keep the battery charged, place
it in the telephone base or handset
charger when not in use.
When it is fully charged, you can expect the following performance:
Operation Operating time
While in handset use (talking*) Up to seven hours
While in speakerphone mode (talking*) Up to three hours
While not in use (standby**) Up to five days
* Operating times vary depending on your actual use and the age of the battery.
** Handset is not charging or in use.
•
•
•
After you install your telephone or power returns following a
power outage, the handset will prompt you to set the date and
time. For instructions, see Set date and time on page 21.
To skip setting, press CANCEL.
Date: MM/DD/YY
ECO
To Next Page
Loading...
Need help?
Technical Specifications
Memory
