EasyManua.ls Logo

VTech IS 8121-3

VTech IS 8121-3
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
Install the battery
NOTES
Use only the battery provided.
Charge the battery provided with this
product only in accordance with the
instructions and limitations specified
in this manual.
If the handset will not be used for a
long time, disconnect and remove
the battery to prevent possible
leakage.
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
BT183342/BT283342 (2.4V 400mAh Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine CR1535
THIS SIDE UP
P / CE CÔTÉ VERS LE HAUT
oc-piles :
3342 (2.4V 400mAh Ni-MH)
VERTISSEMENT :
R PUNCTURE BATTERIES.
U PERCER LES PILES.
chine CR1535
Connect the telephone base
NOTES
Use only the adapters provided.
Make sure the electrical outlets are
not controlled by wall switches.
The adapters are intended to be
correctly oriented in a vertical or
floor mount position. The prongs
are not designed to hold the plug in
place if it is plugged into a ceiling,
under-the-table or cabinet outlet.
TIP
If you subscribe to digital subscriber
line (DSL) high-speed Internet
service through your telephone line,
make sure you install a DSL filter (not
included) between the telephone
line cord and telephone wall jack.
Contact your DSL service provider
for more information.

Table of Contents

Related product manuals