WEARING THE SMARTWATCH
People with very sensitive skin may notice some irritation after wearing
the Kidizoom
®
Smartwatch DX2 for extended periods of time. The skin
may become irritated when moisture, sweat, soap, or other irritants get
trapped under the watch band and are left in contact with the skin. To
prevent this, we suggest children remove the watch before going to bed
for the night, take the watch off if it's feeling uncomfortable, and keep
their wrist and the band clean and dry.
In addition, wearing the watch too tightly may also cause irritation. Make
sure the t is good - tight enough so the watch stays in place but not so
tight that it's uncomfortable. If you notice any redness, swelling, or other
irritation, you may want to consult a doctor before wearing the watch
again.
GETTING STARTED
Master Power Switch
When you use Kidizoom
®
Smartwatch DX2 for the
rst time, you will need to slide the Master Power
Switch (located on the underside of the watch) to
the ON position
. You may need a small tool
such as a paper clip to move the switch to the on
position. Then, fully charge the watch before rst
use. A full charge will take about 3 hours.
When the Master Power Switch is set to the OFF
position, the unit will not function and the battery will not charge. Only
move the switch to the OFF position when the watch will not be used for
an extended period of time.
Note: It is not necessary to switch off the watch in daily use. Once the
master power switch is off, the watch will stop functioning and after it is
turned on again, the time and date has to be reset.
BATTERY RECHARGING
Note: Adult operation required.
To charge Kidizoom
®
Smartwatch DX2, the watch needs to be
connected to a computer with the included Micro-USB Cable. To do so
correctly, please follow these steps:
• Make sure that the Master Power Switch is set to the ON position
before charging.
• Pull up the rubber cover of the Micro-USB Port on the side of the
watch.
To Next Page
Loading...
Need help?
General
