VTech SN5147 - To Register an Extension Ringer (SN7014)

60
Device setup
You can add VTech compatible Cordless
audio doorbell, ULE Cordless extension
ringer and ULE Wearable home SOS
pendant (SN7021, SN7014 and SN7022, all
purchased separately) to your telephone
system.
The Cordless audio doorbell (SN7021)
helps you get notified at your telephone
system upon visitors’ arrival. When a visitor
presses the Audio doorbell, both the base
and the handset will play the chime tone,
and you can then answer the doorbell call
and talk to the visitor at your door with the
handset or base. For operation instructions,
refer to page 62 to page 64.
VTech compatible
ULE devices
The ULE Cordless extension ringer
(SN7014) works as an extra ringer and/or
flashing lights in addition to your handset
and base. It lets you hear and see more
clearly when there is an incoming call.
The ULE Wearable home SOS pendant
(SN7022) function as same as the SOS
button of your cordless handset. It acts
as a handy pendant to let you quickly call
the preset SOS numbers for help in an
emergency, even when your telephone
is beyond your reach. For detailed
setups and operations, refer to Set SOS
emergency call section on page 12 to
page 14, and Make SOS emergency call
section on page 23.
• You can add a maximum of two Cordless
audio doorbells and 30 compatible ULE
devices to your telephone base.
Add and register a new device
• You need to register your newly purchased
devices to the telephone base before use.
• Make sure the new devices are powered
on with batteries or with AC power before
registering them to the telephone base.
To register an Extension ringer
(SN7014):
1. When the telephone is not in use,
press and hold PAGE at the telephone
base for about five seconds until the
visual ringer indicator light turns on.
Release PAGE.
2. Press and hold the pair button on
the right side of the extension ringer
until the green LED light on the front
flashes, then release the button. When
registration is successful, the green
LED light becomes steady on, and
then the base beeps once.
It takes up to 60 seconds to complete
the registration. When the registration
is successful, the green LED light on the
Extension ringer turns to steady on, and
the telephone base beeps and its visual
ringer indicator light turns off.
If registration fails, start again from Step 1
above.
For detailed installation and operation
instructions, refer to the user’s manual of
your Extension ringer.