VTech vt 1030 - V-tech Microphone Unidirectional User Manual

Using the phone
Call timer
Your handset automatically displays
the duration of every external call.
The call time will remain on the
display until 2 seconds after the call
has ended.
Make a call
1. Press .
Enter the telephone number and the number is dialled.
Preparatory dialling
Use preparatory dialling to see and check the number on
the display before you dial out. The display can only show 12
digits at a time, if you enter a number with more than 12
digits, will be displayed to the left of the number to
indicate more digits.
1. Enter the number first then press or to dial.
End a call
1. Press or place the handset back on the base.
Receiving calls
When you receive an incoming call, the telephone will ring and
the icon will flash. If the ringer is set to off, the phone will
not ring but you will hear one short beep tone to alert you.
1. If the handset is not in the
base/charger, press or
to answer the call.
2. To turn the ringer off when receiving a call press the Left soft
key
C
. The display will briefly show
VOLUME OFF
.
Press Right soft key to delete
an incorrect digit.
r
If you have subscribed to a Caller
Display service, your caller’s number
will also be shown. If the number is
withheld the display will show
WITHHELD
C
. If an exact number match is
found in the Directory, the name will
be displayed instead of the number.
See page 33 for more information.
Internal calls
When you receive an internal call, the
calling handset number will be shown
on the handset display.
13

VTech vt 1030 - V-tech Microphone Unidirectional Specifications

General

Brand	VTech
Model	vt 1030 - V-tech Microphone Unidirectional
Category	Cordless Telephone
Language	English