If you have not already set the day and
time, you will need to do this so that
you will know when each message was
received, see page 4.
Call Screening
When a caller is leaving a message
SCREENING?
appears on the display.
Pressing
OK
allows you to monitor the
message being left without the caller
hearing you.
You can then press to accept the
call or
BACK
to stop monitoring.
3. Press or to select
ON
or
OFF
, then press
OK
to confirm
4. Press and hold
to return to standby mode.
Outgoing messages
This is the message your caller hears when the answering
machine picks up their call. Your VT1030 comes with
two pre-recorded outgoing messages to choose from. You can
also record your own outgoing messages.
Answer and Record
This allows your caller to leave a message for you. The pre-
recorded message is “Hello, your call cannot be taken at the
moment, so please leave your message after the tone.”
Answer Only
This does not allow your caller to leave a message.
The pre-recorded message is “Hello, your call cannot be taken
at the moment, and you cannot leave a message, so please
call later.”
Answering machine
37
To Next Page
Loading...
