VU LED32D6545 - 6. Using the Remote Control; Inserting Remote Control Batteries; Operating the Remote Control

12
Using the Remote Control
6
30 30
IR Receive
-/- -
P.MODE
S.MODE
FAV
SLEE P
FREEZE
CH.LIST
AUTO
ASPECT
SOURCE DISPLAY
CH
Operating the Remote Control
Inserting Remote Control Batteries
1 .Aim Remote Control directly at the
Remote Control Sensor on the left
down corner of the TV set.
2 .Remote Control range is at approx.16
feet with angles of approx.30 degree.
3. Avoid obstructions between the
Remote Control and the sensor.
☼If you do not intent to use the remote control
for a long time, remove the batteries.
☼If the remote control does not operate
correctly, or if the operating range .
reduced,replace both batteries with new ones.
1. Remove the battery cover by pulling then lifting the knob on the cover.
2. Insert the batteries, corresponding to the (+) and (-) markings on the battery compartment.
3. Reattach the battery cover.
CAUTION
• Only use the specied AAA batteries.
• Do not mix new and old batteries. This may result in creaking or leakage, which may pose a
risk of re or lead to personal injury.
• Insert batteries according to (+) and (-) markings. Inserting the batteries incorrectly may result
in leakage, which may pose a risk of re or lead to personal injury.
• Dispose of the battery in accordance with local laws and regulations.
• Keep the batteries away from children or pets.
• When the remote control will not to be used for an extended period, remove the batteries.