Darning and bar-tacking: Programs 98 and 99
Using a Pattern
143
Manual • Sewing machine W6 N 2000 Exklusive W6 N 2000 Exklusive • 27/04/2018 • 1.0 • GBR
Prerequisite:
• You have read the safety notes for this sewing machine, see “Safety
Notes” (page 7).
• You have set up the machine in a safe place; see “Setting Up” (page 12).
• You have connected the machine properly, see “Connecting the ma-
chine” (page 12).
• Please take a look on our website www.w6-wertarbeit.com
and selct the Video "Critical for optimal threading of a
W6 N2000 Exklusive".
• Use a W6 Super-Stretch Needle 90 (HAx 1SP) for stretch and non-
stretch fabrics, or a W6 Super-Stretch Needle 75 (HAx 1SP) for thinner
fabrics. If necessary, install a special needle.
• You are using W6 plastic bobbins and thread tension-friendly / lint-free
W6 thread.
• A presser foot that matches the pattern is installed.
Carry out the following steps:
1. Pull the button holder backwards.
! The piece that has been pulled out corresponds with the length of the
darning stitch or the bar; that is, the further out you pull the button
holder, the longer the darning thread or the bar-tack becomes.
2. Thread the upper thread through the opening in the buttonhole foot and
leave the upper thread on the left-hand side.
3. Place the fabric beneath the presser foot in such a way that the needle
sticks into the starting position of the buttonhole.
To Next Page
Loading...
