Maintenance that must be performed by the customer
Maintenance
201
Manual • Sewing machine W6 N 2000 Exklusive W6 N 2000 Exklusive • 27/04/2018 • 1.0 • GBR
13.2.3.6 Checking the hook race for damage
Carry out the following steps:
1. Remove the ‹needle plate›.
2. Insert the W6 plastic bobbin in the black ‹hook race›.
3. Pull the lower thread through the two slots on the left-hand side of the
hook race.
4. Thread the upper thread, see „What do I do with the upper thread?“ >
„Threading the upper thread“ (Page 68).
! Also thread the thread through the needle.
5. Lift the lower thread, see „What do I do with the upper thread?“ > „Taking
up the upper thread with the lower thread“ (Page 75) and pull it out by
about 15 cm.
! When doing so, hold the upper thread with the other hand.
6. Turn the ‹hand wheel› forwards (towards you
) about five times.
! If the thread remains hanging or if it snags, then the hook system is
damaged.
» The hook race has been checked for damage
W6 Tip
Minor needle strikes on the hook race may be removed carefully by means
of fine emery paper (for example, 800-grit).
If the hook race has been severely damaged by needle strikes, it must
be replaced. Visit our W6 WERTARBEIT online shop in the
Spare Parts
category, to order a new hook race.
13.2.4 Machine lighting
The machine is equipped with a maintenance-free LED lamp. Please
contact the W6-WERTARBEIT Customer Service Department in the event
failure.
To Next Page
Loading...
