Wacker Neuson AS 50e - Specific Safety Instructions - Vibratory Rammer as

4 Security
100_0201_si_0002.fm 11
4.8.2 Service
 The machine should only be maintained/repaired by technically trained personnel.
 Use only original spare parts and accessories. This preserves the operational safety of the machine.
Screw connections
All screw connections must meet the prescribed specifications and must be firmly screwed together.
Observe the tightening torques!
The screws and nuts may not be damaged, bent or deformed.
Pay particular attention to:
 Captive nuts and micro-encapsulated screws may not be reused once loosened. The locking effect
is lost.
 Screw connections with adhesive securing/liquid adhesives (e.g. Loctite) must be cleaned after
loosening and must be provided new adhesive.
4.8.3 Personal safety
 Working under the influence of drugs, alcohol, or drugs can lead to serious injuries.
 Protective equipment should be worn for all work. Appropriate personal protective equipment
considerably reduces the risk of injury.
 Remove any tools before the machine is put into operation. Tools that are located on a rotating
machine part can be ejected and cause serious injury.
 Always ensure good footing.
 In the case of extensive work with this machine, long-term vibration-induced damage cannot be ruled
out. For the vibration load of the machine, see chapter Specifications.
 Wear suitable clothing. Keep baggy or loose clothing, protective gloves, jewelry and long hair away
from moving / rotating machine parts. Danger of being pulled!
4.8.4 Handling and use
 Never operate machines whose switches are defective. Have defective switches exchanged
immediately. Machines with defective switches have a high risk of injury.
 Store unused machines out of the reach of children. The machine may only be operated by
authorized personnel.
 Handle the machine with care. Have defective parts exchanged immediately before the machine is
operated. Defective machines have a high risk of accidents.
 Use the machine, accessories, insertion tools, etc. according to these instructions.
4.9 Specific safety instructions - Vibratory rammer AS
4.9.1 External influences
The vibratory rammer may not be operated in the event of the following external influences:
 In an explosive vicinity!
 In the vicinity of a naked flame. Fire hazard!
4.9.2 Take work breaks regularly
When operating this machine for long periods of time, vibration-induced circulatory disorders may occur
to your fingers, hands or wrists.
Symptoms:
 The aforementioned body parts falling asleep, tingling, pain, sharp pains and changes to skin color.
 If you have a personal disposition to poor blood circulation, your working time may be reduced
despite wearing protective gloves and taking regular work breaks.
4.9.3 Operational safety
 When operating the machine, make sure that no gas, water, or electric lines are damaged.
NOTICE
Observe the instructions of the liquid adhesive manufacturer.
NOTICE
If these symptoms are determined, seek medical attention immediately.