15 Accessories
40 100_0201_ac_0002.fm
15 Accessories
A wide range of accessories is offered for the machine.
More information about the individual accessories can be found online at www.wackerneuson.com.
Assembly of the transport roller
Place the machine horizontally on a flat surface with sufficient load-bearing capacity. Secure against
falling over.
1. Put the starter lever in the OFF position.
2. Align the shells centrally to the welding seam of the guide bar.
3. Assemble the shells to the guide bar with four screws. The tightening torque is 2.5 Nm.
CAUTION
Accessories and spare parts that do not originate from Wacker Neuson can increase the
risk of injury and possible damage to the machine.
The use of other accessories and spare parts that do not originate from Wacker
Neuson shall cancel any liability.
NOTICE
Do not place the machine on its side.
Item Designation Item Designation
1 Shells (transport roller) 3 Screws
2 Welding seam 4 Control handle
To Next Page
Loading...
