wc_tx000640gb.fm
29
CRT 36 Maintenance
4.2 Periodic Maintenance Schedule
The table below lists basic machine maintenance. Tasks designated with check
marks may be performed by the operator. Tasks designated with square bullet
points require special training and equipment.
Refer to the engine operator’s manual for information on engine maintenance.
Daily Every
20
hrs.
Every
50
hrs.
Every
100
hrs.
Every
200
hrs.
Every
300
hrs.
Grease trowel arms.
Check fuel level.
3
Check engine oil level.
1
3
Inspect air filter. Replace as needed.
3
Check external hardware.
3
Pressure wash all surfaces until free of
concrete.
2
Check oil level in gearboxes.
3
Grease gearbox, drive system and pitch posts
fittings.
Grease control linkage.
Check drive belt for wear.
3
Change engine oil.
3
Check fuel filter.
3
Clean and check spark plug.
Replace oil filter.
Replace spark plug.
Replace fuel filter.
Replace oil in gearboxes.
1
Check engine oil twice daily (every 4 hours).
2
Pressure wash immediately after use.
3
Change engine oil after first 20 hours of operation.