wc_tx000640gb.fm
39
CRT 36 Maintenance
4.13 Engine Oil and Filter (Honda engine)
Drain oil while engine is still warm.
1. Remove oil fill cap (a) and drain plug (b) to drain oil.
Note: In the interests of environmental protection, place a plastic sheet and a
container under the machine to collect any liquid which drains off. Dispose of this
liquid in accordance with environmental protection legislation.
2. Install drain plug and tighten.
3. Fill engine crankcase with recommended oil to the upper limit mark on the
dipstick (c).
4. Install oil fill cap and dipstick securely.
5. Remove front pedestal panel to access oil filter. To replace the oil filter, remove
the installed oil filter after oil has been drained. Apply a thin coat of oil to the
rubber gasket of the replacement oil filter. Screw the filter on until it just contacts
the filter adapter, then turn it an additional 22.24 mm (7/8 in.) turn. Refill with oil
as described above.
a
b
c
wc_gr000155
WARNING
Most used oil contains small amounts of materials that can cause cancer and other
health problems if inhaled, ingested, or left in contact with skin for prolonged
periods of time.
f Take steps to avoid inhaling or ingesting used engine oil.
f Wash skin thoroughly after exposure to used engine oil.
To Next Page
Loading...
Need help?
General
