What to do if my Wacker Neuson CRT 48 Trowels machine does not move?
If your Wacker Neuson Trowels machine isn't moving, it could be due to a broken drive belt or a vacuum forming between the blades and the concrete surface. Replace the drive belt to fix this. Additionally, adjust the blade pitch to eliminate the suction.
Why is my Wacker Neuson CRT 48 Trowels machine wobbling?
If your Wacker Neuson Trowels machine is out of balance and wobbling excessively, it may be due to operator over-steering, bent trowel arms or blades, or bent main shafts. Avoid applying excessive pressure on control arms. Replace any bent trowel arms, trowel blades, or main shafts.
How to fix poor handling in Wacker Neuson CRT 48?
Poor handling in your Wacker Neuson Trowels, with excessive control lever movement, is often due to worn bushings from lack of lubrication, a shifted control arm lever adjustment, or bent lower control arms. Replace the bushings and lubricate them every 20 hours. Reset the control arm lever. Replace any bent lower control arms. Always use lifting brackets and/or forklift pockets when lifting the machine.
General| Brand | Wacker Neuson |
|---|---|
| Model | CRT 48 |
| Category | Trowels |
| Language | English |
Information on how to obtain manuals and parts books.
Warning about chemicals known to cause cancer and birth defects.
Defines approved and unapproved parts, attachments, and modifications.
Explains DANGER, WARNING, CAUTION, NOTICE, and NOTE signal words.
Describes the trowel and its intended purpose, including misuse examples.
Covers operator qualifications, PPE, and general safety rules.
Focuses on hazards and safety for engines, including refueling.
Illustrates the location of various labels on the machine.
Explains the meaning of international pictorial labels used on the machine.
Steps for initial setup and checks before operating the machine.
Guidelines for the operator's correct and safe seating position.
Specifies the type of gasoline required for Vanguard engines.
Provides instructions and safety precautions for refueling the machine.
Identifies and describes the machine's various features and controls.
Step-by-step guide for starting Kohler engines.
Explains the hand motions required for steering the machine.
Instructions for adjusting the angle of the trowel blades.
Steps to follow in case of breakdown or accident.
A schedule of regular maintenance tasks for the machine and engine.
Procedures for checking and changing gearbox oil.
Details about the steering assist system and its components.
Instructions for replacing the drive belt.
Steps for safely jump-starting a weak battery.
Instructions for cleaning and maintaining the air cleaner.
Procedures for changing engine oil and filter for Vanguard engines.
Procedures for changing engine oil and filter for Kohler engines.
Technical specifications for the engines used in the CRT 48 models.
Technical specifications related to the machine's weight, dimensions, and operation.
Details sound pressure and vibration levels according to ISO standards.
Electrical schematic diagram for the CRT 48-35V model.
List of components referenced in the CRT 48-35V electrical schematic.
Electrical schematic diagram for the CRT 48-35L model.
Electrical schematic diagram for CRT 48-34V and CRT 48-31V models.
To Next Page
