Wacker Neuson CRT 48 User Manual

wc_tx000642gb.fm
35
CRT 48 Maintenance
5.4 Control Linkage Lubrication
The drive system, gearbox and pitch posts are equipped with several grease
fittings. Grease these fittings once a week, or every 20 hours, to prevent wear.
Use a general purpose grease and add one to two shots of grease at each fitting.
5.5 Control Arm Adjustment (Forward or Backward)
The control arms should line up evenly. If arms appear out of adjustment, they can
be re-adjusted forward or backward as follows:
1. Loosen jam nuts (b).
2. Turn the vertical linkage (a) as follows:
 Extend the linkage to adjust control levers forward. See section 4.5 before
extending linkage.
 Shorten the linkage to adjust control levers backward.
3. After the arms have been adjusted to the desired position, tighten jam nuts (b).
NOTICE: Control arms are adjusted as part of the steering assist system.
Changing orientation of the control arms may affect steering effort.
wc_gr003781
b
a
c

Wacker Neuson CRT 48 Specifications

General

Brand	Wacker Neuson
Model	CRT 48
Category	Trowels
Language	English