wc_tx000642gb.fm
33
CRT 48 Maintenance
5 Maintenance
5.1 Maintaining the Emission Control System
For machines sold in North America:
Normal maintenance, replacement, or repair of emission control devices and
systems may be performed by any repair establishment or individual; however,
warranty repairs must be performed by a dealer/service center authorized by
Wacker Neuson. The use of service parts that are not equivalent in performance
and durability to authorized parts may impair the effectiveness of the emission
control system and may have a bearing on the outcome of a warranty claim.
5.2 Periodic Maintenance Schedule
The table below lists basic machine and engine maintenance. Tasks designated
with check marks may be performed by the operator. Tasks designated with square
bullet points require special training and equipment.
Refer to the engine owner’s manual for additional information.
Daily
Every
20
hrs.
Every
50
hrs.
Every
100
hrs.
Every
200
hrs.
Every
300
hrs.
Grease trowel arms.
3
Check fuel level.
3
Check engine oil level.
3
Inspect air filter. Replace as needed.
33 3
Check external hardware.
3
Pressure wash all surfaces until free of concrete.
3
Check coolant level.
3
Check oil level in gearboxes.
3
Grease gearbox input shaft fitting
Grease control linkage.
1
Check drive belt for wear.
3
Change engine oil.
2, 3
Check fuel filter.
3
Clean and check spark plug.
Replace oil filter.
2
Check fan belt.
3
To Next Page
Loading...
Need help?
General
