9 Operation and use
26 100_0202_op_0009.fm
Operation on sloped surfaces
Always stand above the machine within the area of a slope.
Only approach gradients from below (a gradient that can be easily driven up can also be driven down
without any risk).
Do not stand in the direction of descent of the machine.
Do not exceed the maximum allowable slanting position (see Technical Data) chapter.
Only operate the machine for a short time in maximum allowable slanting position.
Vibrating sett paving (paving stones)
When compacting interlocking paving stones, Wacker Neuson recommends the application of the sliding
mechanism in order to avoid damage to the machine and compaction material. See chapter
Accessories.
9.3 Commissioning
9.3.1 Commissioning the machine (manual start)
1. Put the throttle lever in the full throttle position.
2. Pull the decompression lever up.
NOTICE
If the maximum permissible slanting position is exceeded, this results in a failure of the
engine lubrication and therefore inevitably causes a defect of important engine parts.
DANGER
Fire hazard
Jumper cable sprays are highly flammable; they can ignite and cause severe burns.
Do not use jumper cable sprays.
WARNING
The starting crank can cause serious injuries.
Do not use any defective starting cranks.
Only use a clean starting crank.
Item Designation Item Designation
1 Throttle lever 3 Starting crank support
2 Decompression lever
To Next Page
Loading...
Need help?
General
