EH 9 Transport
25
6 Transport
Transporting the machine
The machine must be transported in the carrying case supplied.
1. Remove tool.
2. Turn the offset handle to the back (not present on all machines).
3. If mounted on housing, unscrew radial handle and screw onto supplementary
handle.
4. Place the machine in the carrying case.
5. Wind up the power cable and place in the carrying case.
Note: Do not kink the power cable!
6. Store the tools in the carrying case.
7. Place the carrying case on or into a suitable means of transport.
8. Secure the carrying case against falling over and down or sliding.
WARNING
Improper handling can result in injury or serious material damage.
f Read and follow all safety instructions of this operator's manual, see chapter
Safety.
To Next Page
Loading...
