EasyManua.ls Logo

Wacker Neuson ET42

Wacker Neuson ET42
306 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5-16 BA E19 en* 1.0 * E19_10_500.fm
5 Operation
LED strip
The red LED strip D shows that the vehicle is in operating mode and that
could result in a danger situation in the work area.
5.6 Washer system
The switch is located on the switch panel on the right.
NOTICE
Damage to pump if the reservoir is empty.
Do not actuate the washer system if the reservoir is empty.
Check the level in the reservoir and add a cleaning solution (glass
cleaner) if necessary.
NOTICE
Damage to wiper if the front window is raised.
Do not actuate the wipers if the front window is raised.
Fig. 140
D
Fig. 141
A
Washer system Operation
Wipers on Press switch A into position 1
Wipers off Press switch A into position 0
Spraying on Press switch A into position 2 and hold
Spraying off Release switch A

Table of Contents

Related product manuals