BA E19 en* 1.0 * E19_10_510.fm 5-41
Operation 5
AUX IV - Hydraulic quickhitch system Easy Lock
• Attend specific training before putting into operation. Training must be
given by authorized technical personnel and must be understood by
the operator.
• For safety reasons, the quickhitch must be operated with two control
elements. This avoids opening the quickhitch unintentionally during
work operation.
• The quick coupler system and the attachment support must be
undamaged and clean.
• For more information, see Easy Lock/Powertilt with Easy Lock
Operator’s Manual.
• Store the Easy Lock/Powertilt with Easy Lock operator's manual
together with the vehicle's operator's manual.
Crushing hazard when picking up attachments!
If an attachment is not locked correctly, it can come off and
cause serious injury or death.
► Do not allow anyone to stay in the danger zone.
► Do not use damaged attachments.
► Check pin F must be fully retracted. Otherwise repeat the lock
cycle until check pin F is retracted.
► Ensure safe locking with a rapid succession of stick and
bucket movements as close as possible to the ground.
► Operate the vehicle only with a safely locked attachment.
Danger of crushing when attachments are removed!
If an attachment is not locked correctly, it can tip over and cause
serious injury or death.
► Do not allow anyone to stay in the danger zone.
► Lower the attachment to level and firm ground ensuring
stability.
To Next Page
Loading...
