7-58 BA E19 en* 1.0 * E19_10_710.fm
7 Maintenance
.
The indicator lights can be positioned differently depending on the vehicle
equipment and display element.
The indicator lights can illuminate or blink at different speeds.
The engine warning and engine stop indicator lights may also illuminate
if another fault occurs. This does not depend on the current load.
Level Menu display Description/Measures
There is a serious fault in the system
Level 3 is the last chance, to prevent service regeneration.
After the engine is started, rpm falls down to the idling speed step by
step. The rpm can be increased again, only after carrying out a regener-
ation.
If the vehicle has to be driven through a danger area, turn off ignition
and then turn it on again. However, that should only be done in case of
an emergency, since that could lead to a need of service regeneration.
Measures for the operator:
Fold up the joystick base and run the engine.
There is an irreversible fault in the system
A service regeneration must be carried out or the diesel particulate filter
must be replaced.
It is not possible to have a higher rpm anymore.
The vehicle can only be driven with a lot of limitations.
Measures for the operator:
Contact a Wacker Neuson service center.
To Next Page
Loading...
