24
Operation RCP
7.2 Adjusting the machine
Adjusting the stop screw
1. Set the pressure release lever in the Release/Idle position.
2. Open the protective hood (only installed on some machine designs).
3. Loosen jam nut.
4. Place the workpiece on the fixed knife.
5. Set the stop screw so that the workpiece is perpendicular to the axis of the
machine.
6. Tighten the jam nut.
WARNING
Starting the machine.
Danger of injuries from uncontrolled starting of the machine.
f Remove the plug from the plug receptacle before all work on the machine.
Item Designation
1 Movable knife
2Jam nut
3 Stop screw
4 Fixed knife
5Workpiece
Protective hood (without illustra-
tion)
To Next Page
Loading...
