Wacker Neuson RCP 20 - Technical Data for Accessories

RCP Accessories
51
11.2.5 Technical data for accessories
P-20/25 bending head
Designation Unit HB-20 HB-25
Installation on the cutting ma-
chine
RCP-20 RCP-25
Length x Width x Height mm 190 x 125 x 90 220 x 290 x 130
Weight kg 5.3 8.5
Min. bending radius on the inside
of the workpiece
mm 18
Bending angle ° 180-65* 180-80*
* The smallest possible bending angle depends on the diameter and tensile strength of
the workpiece.
Max. allowable tension strength
of the workpiece
N/mm
2
750
Max. allowable diameter work-
piece
mm 20 25