8
Safety information RCP
3 Safety information
3.1 Principle
State of the art
This machine has been constructed with state-of-the-art technology according to
the recognized rules of safety. Nevertheless, when used improperly, dangers to
the life and limb of the operator or to third persons or damage to the machine or
other materials cannot be excluded.
Proper use
The machine may only be used for cutting reinforcing steel.
The diameter and tensile strength of the reinforcing steel that may be processed
with the machine are dependent on the machine design. Please refer to the
chapter Technical Data for information concerning your machine.
Worksites are construction sites and operations which fabricate reinforcements
or process reinforcing iron. The machine may only be used for legal and permit-
ted purposes.
The machine must not be used for processing the following materials:
Wires
Pipes
Plastics
Wood
Its proper use also includes the observance of all instructions contained in this
operator's manual as well as complying with the required service and mainte-
nance instructions.
Any other use is regarded as improper. Any damage resulting from improper use
will void the warranty and the liability on behalf of the manufacturer. The operator
assumes full responsibility.
To Next Page
Loading...
