RCP Maintenance
37
Distribute the hydraulic oil
1. Insert the plug into the plug receptacle.
2. Run the machine in cutting operation approx. 3 times back and forth. For this
press the ON/OFF switch.
3. Completely extend the thrust bolt.
4. Pull the plug from the plug receptacle.
Top up with hydraulic oil
1. Place the machine so that the oil filler neck points vertically upward.
2. Unscrew the screw plug on the oil filler neck and remove with sealing ring.
3. Fill with hydraulic oil up to the lower edge of the oil filler neck.
4. Screw in the screw plug with sealing ring in the oil filler neck and tighten.
To Next Page
Loading...
