Carburetor Replacement WM 80 Repair
72 wc_tx000522gb.fm
6.3 Removal, Tillotson with composite adapter
See Graphic: wc_gr002929
6.3.1 Stop the machine and allow it to cool.
6.3.2 Close the fuel valve (a) (if equipped).
6.3.3 Disconnect the ignition wire (b) at the spark plug.
6.3.4 Remove the carburetor guard (c).
6.3.5 Loosen the clamps holding the air duct (d) to the carburetor and
remove the air duct from the carburetor.
6.3.6 Remove the two socket head cap screws (e) holding the flange (f) to
the carburetor (g) and remove both the flange and the carburetor.
6.3.7 Disconnect and plug the fuel line(s) (h) to the carburetor.
6.3.8 To remove the carburetor adapter (i), loosen the two screws (j) and the
nut (k) holding the throttle cable (l). Then, remove the two nuts (m) and
remove the carburetor adapter.
To Next Page
Loading...
