29
EPG-SPRINT XE
OPERATING MANUAL
VERSION 09/2017 ORDER NUMBER DOC2354913
6 ASSEMBLY AND COMMISSIONING
6.1 TRAINING ASSEMBLY/COMMISSIONING STAFF
Incorrect installation/operation!
Risk of injury and damage to the device.
The commissioning sta must have the technical skills to safely
undertake commissioning.
When commissioning and for all work, read and follow the
operating manual and safety regulations for the additionally
required system components.
WARNING
6.2 STORAGE CONDITIONS
Until the point of assembly, the control unit must be stored in a dry location, free from
vibrations and with a minimum of dust. The control unit must be stored in closed rooms.
The air temperature at the storage location must be between 5 and 45 °C; 41and113 °F.
The relative air humidity at the storage location must not exceed 75%.
6.3 CONDITIONS OF ASSEMBLY AND COMMISSIONING
The air temperature at the installation site must be between 5 and 40 °C; 41and104 °F.
Depending on the powder lacquer used, the maximum permissible ambient temperature
for reliable operation can be signicantly below +40 °C; 104 °F.
The relative air humidity at the assembly location must not exceed 75%.
To Next Page
Loading...
Need help?
General
