WAGNER EPG-SPRINT XE

37
EPG-SPRINT XE
OPERATING MANUAL
VERSION 09/2017 ORDER NUMBER DOC2354913
7.3.4 BASIC AND FACTORY SETTINGS
The EPG-SPRINT XE control unit is factory-congured for operation with Corona manual
or automatic guns. Consequently, the control unit can be used in a manual system or an
automatic gun without any further settings being required.
However, if the control unit is used with a Tribo manual or automatic gun, the gun type
must be changed. This change is eected in the conguration settings.
For all other settings, congurations and special functions, please refer to the chapter
"Device Conguration".
7.3.3 MANUAL GUN MODE WITH EXTERNAL CONTROL
Application is the recoating of work pieces in an automatic coating system. The recoating
is done with a manual gun, but the powder supply is done by the powder center of the
automatic system. The EPG-SPRINT XE must receive a release signal via the remote interface
so that the device may clean and coat. The cleaning function (continuous ushing) can
also be controlled externally. The function must be selected specically via conguration
parameter C26.
Display on device:
– "Automatic gun" LED ashes quickly No release signal is present
– "Automatic gun" LED is dark Release signal is present