EN
15
CLEANUP
1
2 3
4
5 6
EMPTY WASTE
CONTAINER
FLUSHING THE UNIT GRAVITY FEED NOZZLE ONLY
It is recommended that whenever possible, the
cup should be sprayed until empty. This will
make it easier to clean.
If there is still material in the cup, follow all steps
below. If it is empty, skip to step 5.
Special cleanup instructions for use with
ammable solvents (must have a ashpoint
above 100ºF (38ºC):
• Always ush spray gun outside.
• Area must be free of ammable vapors.
• Cleaning area must be well-ventilated.
• Do not submerge turbine!
1. Switch the turbine OFF. Remove the air hose assembly.
Carefully separate the handle from the spray nozzle.
2. Hold the container steady with one hand, and unthread
the container lid (with air tube still attached).
Make sure not to allow the container to loosen on the
spray gun.
3. Flip the stand down. Carefully tip the container back into
the orginal container to empty any remaining material
back into the material container.
4. Reattach the handle and air hose assembly.
5. Make sure turbine is turned OFF. Using the stand, set the
nozzle upright and pour a small amount of the appropriate
cleaning solution into the container (Water=1/2 full.
Mineral spirits=1/4 full).
6. Replace the container lid. Switch the turbine ON. Spray
the cleaning solution into a safe area.
While spraying, gently shake the spray gun. This slight
agitation will help break up smaller particles of spray
material.
Switch the turbine OFF.
tention
If you cleaned the sprayer using mineral spirits,
repeat steps 5-6 using warm, soapy water.
When cleaning, use the appropriate cleaning
solution (warm, soapy water for latex materials;
mineral spirits for oil-based materials).
Move on to “Cleanup - Cleaning
the Nozzle”, next page.
To Next Page
Loading...
Need help?
General
