Operating Instructions
27
Hourmeter
The hourmeter, which is located on the right front of
the body, displays operating time accumulated
while the PTO (blade drive) clutch is engaged.
The hourmeter provides maintenance reminders af-
ter certain hours of operation. The hourmeter screen
will start flashing the reminder one hour prior to the
recommended interval and will continue until one
hour after the recommended interval (two hours).
The hourmeter does not have a manual reset
function.
Procedure Interval* Reminder
Oil Change
(Break-In)**
4-6 Hours
C
H
G
OIL
Lubricate
and Check
Levels
24-26 Hours
LUBE
Oil Change 49-51 Hours***
C
H
G
OIL
* These intervals reflect the actual time that the
reminder will flash (one hour prior to and one
hour after the recommended interval).
** This reminder is only used one time.
*** In normal operating conditions, oil changes in
100-hour intervals are acceptable. Walker and
the engine manufacturers recommend engine
oil changes every 50 hours in extremely dirty or
dusty conditions or for units with less than 100
hours annual use.
NOTE: The blinking hour glass on the display
means that the meter is operating properly.
Hourmeter
To Next Page
Loading...
Need help?
General
