warema_2035145_alhb_en_v2•2021-04-01
We reserve the right to make technical modifications
10
WMS WebControl pro
3 Commissioning via WMS studio pro
The WMS WebControl pro is configured via WMS studio pro in the project
itself. A WMS Stick is required for this. When the data are transferred to the
devices later on, the entire configuration is transferred.
3.1 Parameterising operation
The interface structure of the operation side is parameterised here.
The maximum number of rooms (logical groups) is 50. The receivers are
assigned to these rooms. Receivers can be created individually or together in
channels. Scenarios, to which any receivers can be assigned, can be created
in addition to the channels. When a scenario is called up, the actions param-
eterised here are executed.
3.2 Parameterising control modes
The control functions are parameterised in the receivers themselves. The re-
ceivers perform these functions independently. The control functions
can only be switched on and off via the WMS WebControl pro.
The WMS WebControl pro has its own time switch, and this can be activated
in the Settings tab (see Chapter 3.3).
Commissioning
To Next Page
Loading...
