warema_2035145_alhb_en_v2•2021-04-01
We reserve the right to make technical modifications
28
WMS WebControl pro
8.3.5 Time switch
Each receiver has its own independent time switch ("decentral time switch"),
and this can be parameterised using the WMS studio pro.
The WMS WebControl pro has its own "central time switch", which relays
move commands to the receiver. As numerous receivers can be assigned
to one switching time, there is no tedious parameterising of each individual
receiver if changes occur.
When a WMS WebControl pro is created in WMS studio pro, you need to
specify whether the central or the decentral time switches are to be used in
the individual receivers.
If you decide to use the central time switch, the time switch commands
parameterised in the receivers will be deactivated.
The control timer for activating and deactivating control functions is still
managed decentrally in the receivers.
8.3.6 Decentral time switch
Each receiver has its own independent time switch ("decentral time switch"),
and this can be parameterised via WMS studio pro.
To parameterise the switching times, a receiver has to be selected first. The
switching times for this receiver can then be edited or deleted altogether by
clicking on the gear wheel symbol.
The switching times are set by following the procedure for the central time
switch described in the section below.
Control modes - Time switch
To Next Page
Loading...
