Water Right Sanitizer Plus ASP2-1054 - OPERATING DISPLAYS AND INSTRUCTIONS; Navigating System Displays (Time, Flow, Capacity, Days); Programming Regeneration Time and Alarms

10 11
STEP 4 – REGENERATION HOUR: The manufacturer has factory set 2:00 A.M.
as the default. This is the hour of day for regeneration and can be reset
by using + or — buttons. “AM/PM” toggles after 12. The default time is
2:00 a.m. (recommended for a normal household). Press next to go to
step 5. Press regen if you need to return to the previous step.
STEP 5 – REGENERATION MINUTES: Set the minutes using + or — buttons.
Press next to go to step 6. Press regen to return to previous step.
To initiate an immediate manual regeneration, press and hold the
regen button for three seconds. The system will begin to regenerate
immediately. The control may be manually stepped through the
regeneration cycles by pressing regen.
STEP 6 – ALARM BUZZER: The manufacturer has factory set “ON” as the
default. Alarm will sound immediately after regeneration if there is no salt
or if another error has occurred. Turn the alarm “OFF” or “ON” using
+ or — buttons. Press next to exit installer programming.
STEP 7 – DISPLAY BACKLIGHT: The manufacturer has factory set “ON” as the
default. Turn the light “OFF” or “ON” using + or — buttons. “OFF”
will turn display backlight off after five minutes of keypad inactivity.
Press next to exit installer programming.
REGEN TIME HOUR
SET
2:00
AM
REGEN TIME MINUTES
SET
2:00
AM
LIGHT NORMALLY
SET
ON
4
2
5
7
ALARM BUZZER
SET
ON
6
DAYS BETWEEN REGEN
SET
6
WATER HARDNESS
SET
20
GR
1 2 3
OPERATING DISPLAYS AND INSTRUCTIONS
1
TIME OF DAY MON
GPM
2:408
PM
FLOW RATE
GPM
8.0
The user can scroll
between the displays
as desired.
1. GENERAL OPERATION: When the system is operating, one of four displays may be shown. Pressing next will alternate
between the displays.
1. CURRENT TIME OF DAY and GPM
2. FLOW RATE which is the current treated water flow rate through the system in Gallons Per Minute
3. CAPACITY REMAINING which is the gallons that will be treated before the system signals a regeneration cycle
4. DAYS TO A REGEN is the number of days left before the system goes through a regeneration cycle, based on
the days override value