WaterLogic CUBE FIREWALL - HOT WATER TROUBLESHOOTING; Locating and Resetting Overloads

CUBE Manual Page 83 - Revision: 5-24-2017
13.
Reach up behind the Hot Tank and take hold of the
protective metal box covering the overloads on the Hot Tank.
There are nuts that secure the metal box to the Hot Tank,
however the nuts are loose enough to remove them metal
box.
14.
Press Red Button on each overload to reset (there are two
reset buttons)
15.
Reassemble unit by using these instructions in reverse.
Location of the two
Hot Tank Overload
Buttons