Waters Extraction+ - Certifications and End of Life; Unit End of Life Information; Electrical Safety, EMC, and Radio Certifications; Manufacturer Contact Information

Unit end of life
When a unit reaches the end of its useful life, contact Waters for directions
and information on the end-of-life policy.
This is in accordance with the European Union Directive 2002/96/EC on
Waste Electrical and Electronic Equipment (WEEE).
Certications
Electrical safety
EMC
RADIO
FCC
RoHS
I. IEC 61010-1: 2010
II. IEC 61010-1/A1: 2016
III. UL 61010-1: 2012
IV. CAN/CSA 22.2#61010-1-12
I. EN 61326-1: 2013
II. EN 301 489-1 V2.2.0
III. EN 301 489-17 V3.1.0
I. EN 300 328 Ver 2.1.1
II. EN 301 893 V2.1.1
I. FCC 47 CFR part 15 subpart B section
15.107 (b) and section 15.109 (b and g)
Class A all over other device tested per
ANSI C63.4 (Ed. 2014) procedures
II. This device complies with Part 15 of
the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful
interference, and (2) This device must
accept any interference received,
including interference that may cause
undesired operation.
RoHS 3 (EU) 2015/863
Andrew Alliance S.A.
Chemin Grenet 21
1214 Vernier (Geneve)
Switzerland
Phone: +41 22 518 0357
Waters Corp
34 Maple Street
Milford, MA 01757
USA
Phone: +1-508-478-2000
aa_contact@waters.com
Part number: 720007721EN version 00 | ©2022 Waters Corporation