Watts Aerco INN 1060N - Unit Status Menu

Innovation - Edge [i] Installation, Operation, Maintenance Manual
CHAPTER 3 – OPERATION
OMM-0143_A • GF-216 • 9/6/2019 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 39 of 170
3.3.1 Unit Status Menu
The Unit Status menu contains the following sections and parameters. Unlike other Edge
menus, navigation starts at the Unit Status screen and proceeds from there by scrolling to the
right.
Main Menu → Unit Status
Target Fire Rate
Read Only
The target Fire Rate (0% to 100%).
Current Fire Rate
Read Only
The current Fire Rate (0% to 100%).
Flame Strength
Read Only
The current Flame Strength (0% to 100%).
Feed Forward
Read Only
The current Feed Forward temperature.
Inlet Temp
Read Only
The current Inlet Water temperature
Air Inlet
Read Only
The current Air Inlet temperature.
Setpoint
Read Only
The unit’s current Setpoint.
Outlet
Read Only
The current Outlet temperature.
Exhaust
Read Only
The current Exhaust temperature.
Main Menu → WHM Cascade Status
Avg Fire Rate
Read Only
The average Fire Rate (0% to 100%).
Units Online
Read Only
The number of units in the WHM cascade online.
Setpoint
Read Only
The WHM cascade’s current Setpoint.
Units Available
Read Only
The number of units in the WHM cascade.
Avg Outlet
Read Only
The average outlet temperature.
Units Firing
Read Only
The number of units in the WHM cascade firing.
Main Menu → Runtime Statistics
Average Cycles Per Hour
Read Only
The unit’s average number of cycles per hour.
Run Hours
Read Only
The number of hours the unit has run since startup.
Cycle Count
Read Only
The number of cycles during unit run hours.
Main Menu → Unit Event History
Event
Read Only
Lists the unit’s warning and fault events.
Main Menu → Plant Event History
Event
Read Only
Lists the plant’s warning and fault events.