Innovation - Edge [i] Installation, Operation, Maintenance Manual
CHAPTER 3 – OPERATION
OMM-0143_A • GF-216 • 9/6/2019 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 41 of 170
Enables/Disables the Spark Monitor.
Minimum spark. (0.00 to 0.29 amps)
Maximum spark. (0.30 to 2.50 amps)
3.3.2.3 Main Menu → Calibration → Combustion Summary
Main Menu → Calibration → Combustion Summary
Displays combustion calibration valve steps.
Displays combustion calibration O2 results.
Displays combustion calibration NOx results.
Displays combustion calibration CO results.
Displays combustion calibration flame strength.
3.3.3 Diagnostics Menu
The Diagnostics menu contains the following sections:
3.3.3.1 Main Menu → Diagnostics → Manual Run
Main Menu → Diagnostics → Manual Run
Enables/disables running in Manual Mode.
Manual fire rate adjustment, 0 to 100%
The percentage of O
2
in the unit’s exhaust
The flame strength sensed in the burner, 0 to 100%
3.3.3.2 Main Menu → Diagnostics → Front Panel
Main Menu → Diagnostics → Front Panel
Starts the Touchscreen Display Test.
Starts the Touchscreen Test.
Starts the Status Light Test.
Starts the Keypad and Switch Test.
3.3.3.3 Main Menu → Diagnostics → Analog Outputs and Relays
Main Menu → Diagnostics → Analog Outputs and Relays → Relays
Enables/Disables the Ignition Relay.
Enables/Disables the Blower Relay.
Enables/Disables the Pump Relay.
Enables/Disables the Aux Relay.
Enables/Disables the Fault Relay.
Main Menu → Diagnostics → Analog Outputs and Relays → Analog Outputs
Adjustable display of the A/F valve Position .
Adjustable display of the Blower.
To Next Page
Loading...
