Innovation - Edge [i] Installation, Operation, Maintenance Manual
CHAPTER 3 – OPERATION
OMM-0143_A • GF-216 • 9/6/2019 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 37 of 170
This button allows you to finalize a selection (for instance, a selected from a
menu or from a pop-up (for example, password entry input completion).
Note, all alphanumeric data entry is entered in the touchscreen.
A red light Indicates that the Controller is in a Fault condition.
Clears a fault – the red Fault light goes out.
If the touchscreen becomes non-responsive at any time, simply press the CLEAR button; this
resets the touchscreen and should clear the problem.
3.2.1 Touchscreen Button Functionality
Some of the same Soft-Key controls, as well as some additional controls, appear within the
Controller’s touchscreen. They function as follows:
TABLE 3.2.1: Touchscreen Controls
Takes you to the previous screen.
Takes you to the touchscreen’s Main Menu (see Figure 3.3). If pressed during
a procedure, it aborts the procedure.
The LEFT arrow moves to previous point in the array or list and RIGHT arrow
moves to next point in the array or list.
The UP arrow increases a value, DOWN decreases value.
The arrows on left and right edges of the touchscreen scroll Page Left or
Page Right in a round-robin sequence.
On screens with multiple pages, the Page Up and Page Down buttons
moves up and down the pages.
The Abort button appears when a process may need to be exited prior to
completion.
Pressing Next takes you to the next screen in a multi-step procedure. Some
procedures have a Proceed button instead.
1. Pressing SAVE on a pop-up screen saves the entered data and returns
you to the previous screen.
2. Pressing SAVE on a non-popup screen saves the entered data and takes
you to the next screen.
Pressing Retry takes you to the previous screen and re-attempts the process
step that caused the notification message to appear.
Takes you to a Help screen specific to the subject.
To Next Page
Loading...
