Watts Aerco INN 1060N - Main Menu → Advanced Setup

Innovation - Edge [i] Installation, Operation, Maintenance Manual
CHAPTER 3 – OPERATION
OMM-0143_A • GF-216 • 9/6/2019 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 43 of 170
Main Menu → Diagnostics → Comm & Network → BAS
BAS
Read Only
The Building Automation System protocol.
Communication
Address
Read Only
The unit’s BAS address.
Device Instance
Read Only
The unit’s Device Instance within BAS.
Unit IP Address
Read Only
The unit’s IP address on the network.
Unit MAC Address
Read Only
The unit’s MAC address within BAS.
Last Command
Received
Read Only
The last command received by the unit.
BAS IP
Read Only
If Security is enabled, this is the IP of the BAS system
that the unit can only communicate with.
Network Status
Read Only
The unit’s BAS network’s current status.
Main Menu → Diagnostics → Comm & Network → onAER
Unit IP Address
Read Only
The unit’s IP address.
Upload Time
Read Only
Frequency at which the unit transmits data to onAER
Test Setup
Enable
Initiates test o onAER functionality.
Test Heartbeat
Enable
Initiates test of the onAER heartbeat.
Main Menu → Diagnostics → Comm & Network → USB Storage
Status
Read Only
Status of the USB device.
Serial Number
Read Only
The serial number of the USB device.
Size
Read Only
The size of the USB device.
Available Space
Read Only
The amount of free space on the USB device.
3.3.3.7 Main Menu → Diagnostics → Input/Output Summary
Main Menu → Diagnostics → Input/Output Summary
Air Inlet
Read Only
Displays the current air inlet temperature.
Exhaust
Read Only
Displays the current exhaust temperature.
Outlet
Read Only
Displays the current outlet water temperature.
Lower Inlet
Read Only
Displays the current lower inlet temperature.
Feed Forward
Read Only
Displays the current Feed Forward temperature.
Blower
Read Only
Displays the current Blower voltage.
Remote Ain
Read Only
Displays the value of Remote Analog In.
Cascade Valve
Read Only
Displays the state of the Cascade Valve.
Cascade Vlv Fdbk
Read Only
Displays the Cascade Valve feedback.
Outside Temp
Read Only
Not in use.
3.3.4 Main Menu → Advanced Setup
The Advanced Setup menu contains the following sections:
Main Menu → Advanced Setup → Access
Password
Numeric Entry
Enter 159 or your password, then press Save.