Watts Aerco INN 1060N - Page 42

Innovation - Edge [i] Installation, Operation, Maintenance Manual
CHAPTER 3 – OPERATION
OMM-0143_A • GF-216 • 9/6/2019 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 42 of 170
3.3.3.4 Main Menu → Diagnostics → Subsystems
Main Menu → Diagnostics → Subsystems → Air Fuel Valve Stepper Motor
Auto Stroke
Toggle
Initiates A/F cycle, 0 to 100 to 0%
Valve Position In
Adjust
Manual adjustment of A/F Valve 0 to 100%.
Main Menu → Diagnostics → Subsystems → Blower
Profile
Select
Select the profile to run (default = Profile 1).
Profile Run
Enable/Disable
Enables running the selected profile.
Blower
Numeric Entry
Manually adjust the Blower’s voltage.
Main Menu → Diagnostics → Subsystems → Ignition
Ignition Spark
Enable/Disable
Enables testing the unit’s ignition spark.
Spark Current
Read Only
The current Spark Current.
3.3.3.5 Main Menu → Diagnostics → System
Main Menu → Diagnostics → System → Pre-Start Up
Pre-Start Up Mode
Enable/Disable
Enables Pre-Start Up Mode, a test of various system
components without firing the unit.
Valve Position Out
Read Only
The current A/F valve position.
Blower (voltage)
Read Only
The current Blower voltage.
Blower (RPM)
Read Only
The current Blower RPM.
Spark Current
Read Only
The current Spark Current.
Main Menu → Diagnostics → System → Versions
Serial Number
Read Only
The unit’s serial number.
Software Version
Read Only
The Controller’s software version.
Graphic Data Version
Read Only
The Controller’s graphic version.
Display Version
Read Only
The Controller’s display version.
I/O Board Version
Read Only
The I/O board version.
Touch Version
Read Only
The touch screen version.
Bluetooth Version
Read Only
The Bluetooth version.
Framework Version
Read Only
The Framework version.
Bootloader version
Read Only
The Bootloader version.
Display BL Version
Read Only
Display Bootloader version.
I/O PCB BL Version
Read Only
I/O Board PCB Bootloader version.
3.3.3.6 Main Menu → Diagnostics → Comm & Network
Main Menu → Diagnostics → Comm & Network → IP Network
Unit IP Address
Read Only
The unit’s IP address.
Subnet Mask
Read Only
The unit’s subnet mask address.
Gateway IP Address
Read Only
The unit’s gateway IP address.
DSN 1
Read Only
The unit’s DSN 1 address.
DSN 2
Read Only
The unit’s DSN 2 address.
Unit MAC Address
Read Only
The unit’s MAC address.
Network Status
Read Only
The unit’s current network status.