CHAPTER 3. OPERATION
3.1 INTRODUCTION
The information in this Chapter provides a guide to the operation of the Innovation Water Heater
using the Edge Controller mounted on the front of the unit. It is imperative that the initial startup
of this unit be performed by factory trained personnel. Operation prior to initial startup by factory
trained personnel will void the equipment warranty. In addition, the following WARNINGS and
CAUTIONS must be observed at all times.
CAUTION!
All the installation procedures in Chapter 2 must be completed before attempting to start the
unit.
WARNING!
ELECTRICAL VOLTAGES IN THIS SYSTEM INCLUDE 110 OR 220 AND 24 VOLTS AC. IT
MUST BE SERVICED ONLY BY FACTORY CERTIFIED SERVICE TECHNICIANS.
WARNING!
DO NOT ATTEMPT TO DRY FIRE THE UNIT. STARTING THE UNIT WITHOUT A FULL
WATER LEVEL CAN SERIOUSLY DAMAGE THE UNIT AND MAY RESULT IN INJURY TO
PERSONNEL OR PROPERTY DAMAGE. THIS SITUATION WILL VOID ANY WARRANTY.
3.2 EDGE CONTROLLER DESCRIPTION
The Innovation’s Edge Controller, shown in Figure 3.1, contains all of the controls, indicators
and displays necessary to operate, adjust and troubleshoot your Innovation Water Heater.
The Edge Controller contains a capacitive touchscreen, which is a highly sensitive device. It
continuously checks for user interaction at a very high frequency. Mechanical room
environments are sometimes harsh, electromagnetically noisy and dirty, and can experience
wide temperature ranges, and can be difficult for sensitive electronic components.
To Next Page
Loading...
